请问大峡,我移植的linux-2.6.27-9260-ek,写进去后没有启动

只看该作者 · 2011-5-4 14:58

U-Boot 1.1.5 (Jun  4 2010 - 12:54:39)
DRAM:  64 MB
NAND:  NAND device: Manufacturer ID: 0xec, Chip ID: 0x75 (<NULL> NAND 32MiB 3,3V 8-bit)
2048 byte HW ECC not possible on 512 byte page size, fallback to SW ECC
32 MiB
DataFlash:AT45DB161
Nb pages: 4096
Page Size: 528
Size= 2162688 bytes
Logical address: 0xC0000000
Area 0: C0000000 to C0003FFF (RO)
Area 1: C0004000 to C0007FFF
Area 2: C0008000 to C0037FFF (RO)
Area 3: C0038000 to C020FFFF
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
DM9161A PHY Detected
No link
MAC: error during RMII initialization
Hit any key to stop autoboot:  1 0
NAND read: device 0 offset 0, size 2097152 ...  2097152 bytes read: OK
NAND read: device 0 offset 2097152, size 5242880 ...  5242880 bytes read: OK
## Booting image at 20400000 ...
Image Name: linux-2.6.27-9260-ek
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1189160 Bytes =  1.1 MB
Load Address: 30007fc0
Entry Point:  30008000
Verifying Checksum ... OK
OK
Starting kernel ...

大峡们:偶是第一次移植linux,请大峡们帮我看看,怎么不启动内核了?
load address:0x30008000
entry point :0x30008040
这个我也试过,不行
分析下