此消息从JLINK最新更新版本中获得：
We are pleased to announce the availability of a new version of the J-Link software and
documentation pack V4.96 with the following changes:
- DLL: Improved SEGGER RTT speed.
J-Link V9 and later: Up to 500 KB/s RTT read speed
J-Link ULTRA+/PRO V4 and later: Up to 1 MB/s RTT read speed
- DLL/J-Flash: Added flash programming support for NXP LPC822 / LPC824 devices.
- DLL/J-Flash: Added flash programming support for Atmel ATSAMV70 (Cortex-M7) series devices.
- DLL/J-Flash: Added flash programming support for Atmel ATSAMV71 (Cortex-M7) series devices.
- DLL/J-Flash: Added flash programming support for Freescale WPR1516 (Cortex-M0) series devices.
- DLL/J-Flash: Added flash programming support for ST STM32F091xB and STM32F091xC devices.
- DLL/J-Flash: Flash programming for Atmel Cortex-M7 based devices did not restore device state properly after programming. Fixed.
- DLL: Added flash programming support for Atmel ATSAME70 (Cortex-M7) series devices.
- DLL: Added flash programming support for Atmel ATSAMS70 (Cortex-M7) series devices.
- DLL: Added flash programming support for Atmel ATSAMC20 series devices.
- DLL: Added flash programming support for Atmel ATSAMC21 series devices.
- DLL: Added flash programming support for Atmel ATSAMH21 series devices.
- DLL: Added flash programming support for Atmel ATSAML21 series devices.
- DLL: Added flash programming support for Atmel ATSAMV21 series devices.
- DLL: Added support for TI RM57L843ZWT and TMS570LC4357ZWT devices (Cortex-R5).
- DLL: Added some SiLabs C8051 (C2 interface) devices.
- DLL: Added some device aliases for some SAMD21 devices.
- DLL: Reading FPU registers on Cortex-M7 caused error messages, even if FPU was enabled. Fixed.
- DLL: Added command to suppress device selection dialog on unknown device names. |
楼主
标题置顶
标题高亮
