用STM32F407作为主机，N32G430作为从机，主机发送一个8位数据，从机通过SPI2接收并存到变量rec里。目前主机信号发送正常，从机程序每次都跑死在 while (SPI_I2S_Flag_Status_Get(SPI_SLAVE, SPI_I2S_FLAG_RNE) == RESET)这一步。查了用户手册说这个标志位会在接收数据后硬件清除，不知道怎么回事。贴出部分程序，求大神解答qwq。
SPI_Initializes_Structure(&SPI_InitStructure);
SPI_InitStructure.DataDirection = SPI_DIR_DOUBLELINE_FULLDUPLEX;
SPI_InitStructure.SpiMode = SPI_MODE_SLAVE;
SPI_InitStructure.DataLen = SPI_DATA_SIZE_8BITS;
SPI_InitStructure.CLKPOL = SPI_CLKPOL_LOW;
SPI_InitStructure.CLKPHA = SPI_CLKPHA_FIRST_EDGE;
SPI_InitStructure.NSS = SPI_NSS_SOFT;
/* It is recommended that the SPI master mode of the C version chips should not exceed 18MHz */
SPI_InitStructure.BaudRatePres = SPI_BR_PRESCALER_8;
SPI_InitStructure.FirstBit = SPI_FB_MSB;
SPI_InitStructure.CRCPoly = 7;
SPI_Initializes(SPI2, &SPI_InitStructure);
SPI_Set_Nss_Level(SPI2, SPI_NSS_LOW);
SPI_CRC_Enable(SPI_SLAVE);
SPI_ON(SPI_SLAVE);
while (1)
{
while (SPI_I2S_Flag_Status_Get(SPI_SLAVE, SPI_I2S_FLAG_RNE) == RESET)
rec = SPI_I2S_Data_Get(SPI_SLAVE);
}
|
|
楼主
