仿真器是，xds510，驱动已经安装好，以下为错误显示：
Can't Initialize Target CPU:
Error 0x80001240/-1058
Fatal Error during: Initialization, OCS, Target,
Device driver: Emulator Controller not responding
It is recommended to RESET EMULATOR. This will disconnect each
target from the emulator. The targets should then be power cycled
or hard reset followed by an emureset and reconnect to each target.
I/O Port = 240
Board Name: C5401 XDS510 Emulator
Cpu Name: CPU_1
Abort: Close Code Composer Studio.
Retry: Try to initialize the target again.
Ignore: Ignore the initialization error and start
without target debugging access.
Diagnostic: Run diagnostic utility.
请大家帮个忙，急！！！ |
|
楼主
